Toshiba e-studio555 - Exit Guide; Exit;Reverse Guide; Reading End Guide

e-STUDIO555/655/755/855 © 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
15 - 22
15.5.11 Exit guide / Exit/reverse guide / Reading end guide
(1) Take off the platen sheet unit.
 P.15-19 "15.5.8 Platen sheet unit"
(2) Remove the RADF exit tray.
 P.15-20 "15.5.9 RADF exit tray"
(3) Take off the original exit motor.
 P.15-41 "15.5.29 Original exit motor
(MR4)"
(4) Take off the original reverse motor.
 P.15-41 "15.5.28 Original reverse motor
(MR3)"
(5) Remove 1 clip, 1 pulley, 1 timing belt and 1
pin.
Fig. 15-36
(6) Disconnect 1 connector. Remove 1 clip and
take off the rear side guide bushing.
Fig. 15-37
(7) Remove 1 screw and take off the leaf spring.
Fig. 15-38
Timing belt
ClipPin
Pulley
ClipConnector
Guide bushing