Toshiba e-studio555 - Reading Start Roller

e-STUDIO555/655/755/855 © 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved
REVERSING AUTOMATIC DOCUMENT FEEDER (RADF)
15 - 30
15.5.18 Reading start roller
(4) Remove 1 E-ring and 1 bushing (front side).
Slide the intermediate transport roller,
remove 1 pulley and 1 bushing, and take off
the intermediate transport roller.
Note:
When installing the intermediate transport
roller, refix the loosened screw and tighten
the belt tension.
Fig. 15-61
(1) Take off the reading start guide unit.
 P.15-21 "15.5.10 Reading start guide unit"
(2) Loosen 1 screw.
Fig. 15-62
(3) Remove 1 screw. Remove 1 timing belt, 1
pulley and 1 bearing.
Fig. 15-63
Bushing
E-ring
Bushing
Pulley
Intermediate transport roller
Bearing
Pulley