© 2009 - 2011 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO555/655/755/855
REVISION RECORD
1
REVISION RECORD
Ver.05
Ver.04
Ver.03
Ver.02
Ver.05<2011.4.25>
Page Contents
Trademarks The descriptions of Windows 95, 98, Me and 2000 have been deleted.
The description of Windows 7 has been added.
9-1 The chapter numbers have been corrected.
12-1 The chapter number has been corrected.
16-8 The AC wire harness connection diagram (Fig. 16-2) has been replaced.
Ver.04 <2010.12.8>
Page Contents
5-7 A message item "101" has been added to the table.
Ver.03 <2010.1.21>
Page Contents
Precaution The label illustration has been added.
1-1 TWD model has been corrected.
18-1 Signal name has been corrected.
Ver.02<2009.10.2>
Page Contents
PRECAUTIONS The value for the voltage/current has been added.
PRECAUTIONS The value for the voltage/current has been added.
1-2 The paper size "Full Bleed 12x18" for the drawer has been deleted.
1-3 The value for the voltage/current has been added to the power requirements.
1-16 The destination of the power cable has been corrected.
2-7 S53 has been added to Fig. 2-5.
2-8 S53 has been added to Fig. 2-6.
2-35 S53 has been added to the list.
6-11 The name has been corrected from "APS operation sensor" to "Platen sensor".
6-24 The disassembling procedure of the platen sensor has been added.
9-11 "Note" for the screws to fix the motor has been added.
10-14 "Note" for the screws to fix the motor has been added.
11-13 "Note" for the screws to fix the motor has been added.
11-15 "Note" for the screws to fix the motor has been added.
11-16 "Note" for the screws to fix the motor has been added.
11-27 "Note" for the screws to fix the motor has been added.
12-13 "Note" for the screws to fix the motor has been added.
13-6 The numbers of the counter for C490 and C474 have been exchanged.
13-28 "Note" for the screws to fix the motor has been added.
17-3 Fig. 17-5 (drawing of the SLG PC board) has been changed.
To Next Page
Loading...
