Toshiba e-STUDIO556 - Page 165

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 19
Note:
Rotate the drive pulley to move the carriage.
Fig. 4-52
(3) Remove the seal and then disconnect 1
connector.
Fig. 4-53
(4) Remove 3 screws, and take off the Exposure
lamp cooling fan-1.
Note:
When installing the fan, do not tighten the
screw too much.
Fig. 4-54
Drive pulley
Seal
Exposure lamp
cooling fan-2