Toshiba e-STUDIO556 - Page 180

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 34
[ 4 ] Transport sensor (S33/S39/S45/S51)
[ 5 ] Feed clutch (CLT6/CLT8/CLT10/CLT12) and Transport clutch (CLT5/CLT7/CLT9/
CLT11)
(1) Remove 1 screw to take off the transport
sensor with its bracket.
(2) Disconnect 1 connector to take off the
transport sensor.
Note:
When installing the sensor, make sure the
sensor arm moves properly.
Fig. 4-95
(1) Release the harness from the harness
clamp. Then remove 1 screw to take off the
clutch cover.
Fig. 4-96
(2) Disconnect each connector and remove 1 E-
ring to take off the feed clutch and transport
clutch.
Notes:
1. When installing the clutch, do not insert
the wrong harness.
2. Fit in the protrusion of the clutch to the
stopper.
3. When fixing the clutch with the E-ring, be
sure that the one side of the E-ring latch
does not overlap the flat part of the shaft.
Fig. 4-97
Transport sensor
Clutch cover
Harness: Black
Harness: Purple
Feed clutch
Transport clutch