e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 50
[ 2 ] Tandem LCF end fence motor (M42)
(1) Remove 1 E-ring and take off 1 bushing.
(2) Disconnect 1 connector, remove 3 screws
and take off the motor with the bracket.
When assembling, wire the harness and fix it
with filament tape as shown in the figure.
(Be sure not to wire it on the side of the
motor.)
Fig. 4-141
Fig. 4-142
(3) Release 2 gear latches and remove the gear.
Fig. 4-143
Tandem LCF
end fence motor
Bushing E-ring
Motor
Filament tape
Harness
Harness
Motor
Gear
Latch
To Next Page
Loading...
