Toshiba e-STUDIO556 - Page 197

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 51
[ 3 ] Tandem LCF end fence solenoid (SOL8)
[ 4 ] Tandem LCF bottom sensor (S71)
(4) Remove 3 screws and take off the tandem
LCF end fence motor.
Fig. 4-144
(1) Remove 4 screws and take off the bracket.
(2) Remove 1 screw and take off the tray-up unit
side wall.
(3) Remove 2 screws, disconnect 1 connector,
and take off the tandem LCF end fence
solenoid.
Fig. 4-145
(1) Remove 2 screws and take off the plates.
Fig. 4-146
Tandem LCF
end fence motor
Tandem LCF
end fence solenoid
Bracket
Side wall