e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 78
(5) Remove the bearing, the E-ring, and then the
gear and the parallel pin.
(6) Remove 2 screws of the developer sleeve
holder on the rear side.
(7) Take off the upper and lower developer
sleeve with the holder.
Fig. 4-221
(8) Remove 2 pole position fixing bushings, and
then 2 E-rings.
(9) Remove 4 E-rings and then 2 gears.
Fig. 4-222
(10) Remove the developer sleeve holder on the
front and rear side.
Fig. 4-223
Developer sleeve holder
Screw
Bearing, E-ring, Gear, Pin
Pole position
fixing bushing
Gear
Developer sleeve holder
To Next Page
Loading...
