Toshiba e-STUDIO556 - Exit Guide; Exit;Reverse Guide; Reading End Guide

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 123
4.12.11 Exit guide / Exit/reverse guide / Reading end guide
(1) Take off the platen sheet unit.
( P.4-120 "4.12.8 Platen sheet unit")
(2) Remove the RADF exit tray.
( P.4-121 "4.12.9 RADF exit tray")
(3) Take off the original exit motor.
( P.4-142 "4.12.29 Original exit motor
(MR4)")
(4) Take off the original reverse motor.
( P.4-142 "4.12.28 Original reverse motor
(MR3)")
(5) Remove 1 clip, 1 pulley, 1 timing belt and 1
pin.
Fig. 4-346
(6) Disconnect 1 connector. Remove 1 clip and
take off the rear side guide bushing.
Fig. 4-347
(7) Remove 1 screw and take off the leaf spring.
Fig. 4-348
Timing belt
ClipPin
Pulley
ClipConnector
Guide bushing