Toshiba e-STUDIO556 - Input Check (Test Mode 03)

5
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
SELF-DIAGNOSTIC MODE
5 - 7
5.3 Input check (Test mode 03)
<Operation procedure>
Note:
Initialization is performed before the equipment enters the test mode.
Fig. 5-5 Example of display during input check
Refer to "Appendix" in this manual for the items to be checked and the condition of the equipment when
the buttons [A] to [H] are highlighted.
The status of each input signal can be checked by pressing the [FAX] button, [COPY] button and
the digital keys in the test mode (03).
[0][3]
[POWER]
[START]
[FAX]
[COPY]
or
[SCAN]
[Digital keys]
[CLEAR]
(LCD ON)
[POWER] OFF/ON
(Exit)
[CLEAR]