Toshiba e-STUDIO556 - Page 496

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
PREVENTIVE MAINTENANCE (PM)
7 - 28
* 15. Transfer belt power supply roller
Fully clean up the toner and such adhered to the roller with alcohol since an image failure
may occur if there remains any blot on the roller.
Fig. 7-26
(3) Vacuum off the toner inside and the supply
section of the recycle toner hopper.
Fig. 7-23
(4) Remove 1 screw and take off the cover of the
supply opening.
(5) Vacuum off the toner in the auger section.
Fig. 7-24
Note:
When cleaning the auger section with a
vacuum cleaner, be sure to ground the motor
bracket to prevent the motor from being
damaged by static electricity.
Fig. 7-25
Recycle toner hopper
Supply section
Cover
Auger section
Connected to earth
Blot