Toshiba e-STUDIO556 - Hard Disk (HDD)

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
REPLACEMENT OF PC BOARDS / HDD
9 - 4
9.1.5 Hard disk (HDD)
[A] Nomal hard disk (SATA-HDD)
[B] Security hard disk (ADI-HDD)
(1) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(2) Remove the SYS board cover.
( P.9-1 "9.1.1 SYS board cover")
(3) Disconnect 1 connectors and remove 1
screw to take off the ground wire.
(4) Remove 4 screws and remove 4 washers to
take off the HDD with its bracket.
Note:
Be sure that any vibration is not transmitted
to the HDD.
Fig. 9-9
(5) Remove 4 screws and take off the HDD and
the ground wire from the brackets.
Fig. 9-10
(1) Take off the rear cover.
( P.4-5 "4.1.13 Rear cover")
(2) Remove the SYS board cover.
( P.9-1 "9.1.1 SYS board cover")
(3) Disconnect 1 connectors and remove 1
screw to take off the ground wire.
(4) Remove 4 screws and remove 4 washers to
take off the HDD with its bracket.
Note:
Be sure that any vibration is not transmitted
to the HDD.
Fig. 9-11
HDD
Bracket
HDD
HDD