Toshiba e-STUDIO556 - General Operation

3
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
OUTLINE OF THE MACHINE
3 - 39
3.6 General Operation
3.6.1 Overview of Operation
3.6.2 Description of Operation
[ 1 ] Warming-up
1. Initialization
Turning the power ON
→ The IH coil is turned ON.
→ The set number "1" reproduction ratio "100%" and "WAIT WARMING UP" appears.
→ The fan motors are turned ON.
→ Initialization of the scanning system
- The carriage moves to the home position and stops.
- The carriage moves to the peak detection position.
- The exposure lamp (EXP) is turned ON.
- Peak detection (a white color is detected by the shading correction plate)
- The exposure lamp (EXP) is turned OFF.
- The carriage moves to the home position.
→ Initialization of the feeding system
- Each drawer tray goes up
→ Initialization of the writing system
- The polygonal motor (M2) rotates at a high speed. (e-STUDIO756/856)
- The polygonal motor (M2) rotates at a low speed. (e-STUDIO556/656)
- The beam position is controlled. (e-STUDIO756/856)
→ Other
- The main charger cleaner operates.
2. Pre-running operation
The pre-running operation starts when the temperature of the fuser roller surface reaches a certain
degree. (Pre-running is not performed when the fuser roller is already hot enough.)
→ The fuser motor (M3) is turned ON.
- The fuser roller rotates.
→ The drum motor (M11) is turned ON.
- The drum rotates.
→ The used toner transport motor (M9) is turned ON
- The used toner transport auger rotates.
→ Image quality control
- It charges the drum and detects the drum surface potential to set the optimal condition for
outputting the image.
- It forms a patch on the drum and reads out its reflective ratio to set the optimal condition.
3. When the surface temperature of the fuser roller becomes sufficient for fusing;
→ The IH coil (IH-COIL) is turned OFF.
→ The set number "1" and "READY" are displayed.
Copier operation
Operation during warming-up, pre-running and standby
Copying operation
Automatic feed copying by pressing [START] button
Bypass copying
Interrupt copying