Toshiba E-STUDIO600 - Page 70

e-STUDIO520/600/720/850 ERROR CODE AND SELF-DIAGNOSTIC MODE March 2005 © TOSHIBA TEC
2 - 46
270 Transfer Temperature/humidity sen-
sor Temperature display
ALL 22
<0-100>
M The temperature of the
inside of the equipment
is displayed.
[Unit: °C]
2
286-0 Laser Laser power
adjustment
1st laser ALL Refer to
contents
<0-255>
M When the value
increases, the laser
power output increases.
<Default value>
e-STUDIO520,
e-STUDIO600,
e-STUDIO720: 132
e-STUDIO850: 101
14
286-1 2nd laser ALL 101
<0-255>
M When the value
increases, the laser
power output increases.
* Valid only for
e-STUDIO850
14
290 Image
quality
control
Image quality control
enforcement
ALL - M Image quality control is
performed forcibly when
the density correction of
the image is required.
6
291 Image
quality
control
Control status display of
image quality control
ALL 0
<0-2,4>
M The control status of
image quality control is
displayed.
0: Normal
1: Error (control stopped)
2: Error (abnormal pat-
tern density)
4: Sensor LED off-level
abnormality or sensor
LED light amount abnor-
mality
2
292 Image
quality
control
Image quality
sensor output
value display
Light
source off
ALL 0
<0-1023>
M The output value of the
image quality sensor
(while the sensor light
source is turned off) is
displayed.
2
293 Drum sur-
face
ALL 0
<0-1023>
M The output value of the
image quality sensor of
the drum surface (when
no test pattern exists) is
displayed.
2
294 Image
quality
control
Low density pattern sen-
sor output value
ALL 0
<0-1023>
M The value of the low den-
sity pattern detected at
the image quality closed-
loop control is displayed.
2
295 High density pattern sen-
sor output value
ALL 0
<0-1023>
M The value of the high
density pattern detected
at the image quality
closed-loop control is
displayed.
2
296 Image
quality
control
Result display of image
quality sensor light amount
adjustment
ALL 0
<0-255>
M The result of the sensor
LED light amount adjust-
ment (to use the reflec-
tion amount from the
drum surface as a refer-
ence) is displayed.
2
Adjustment mode (05)
Code
Classi-
fication
Items
Func-
tion
Default
<Accept-
able
value>
RAM Contents
Proce-
dure
05/11