e-STUDIO5506AC/6506AC/7506AC (Ver01) © 2016, 2017 TOSHIBA TEC CORPORATION All rights reserved
1 - 9
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
(3) Perform automatic calibration for each type of paper whose density has been adjusted by means of the
following flowchart.
* This flowchart is common for the Full color and Black modes.
<Hint> Automatic calibration
In paper types whose density has been adjusted, automatic calibration is performed for
all MFP modes in the following table. However, automatic calibration for each paper
type can be performed separately by changing the value of 08-9059 from "0" (default) to
"1". Automatic calibration only for paper types whose density has been adjusted can also
be performed; however, it is recommended to perform it for other paper types as well.
How to perform automatic calibration
Perform step (1) referring to "2.13 To Obtain a Good Color Balance on
Thick Paper". Perform step (2) and later if required.
Perform step (2) referring to "3.2 To Maintain a Steady Color Balance on
Thick Paper or Special Paper".
After automatic calibration, perform printing and check the image quality.
If further image quality adjustments are necessary, perform the next step.
(4) Check the life of the consumables (particularly the drum and transfer belt unit) and replace them, if
necessary.
• When replacing any consumable, use steps (a) to (b).
(a) Enter the PM support mode. Reset the counter corresponding to the replaced consumable to "0."
* For further information regarding the PM support mode, refer to the Service Manual.
Be sure to reset the counter. Otherwise, it may cause a loss in performance, including degradation
in the image quality and a reduction in the life of the consumables.
No automatic
calibration for each
paper type
Set "1" for code 08-9059.
Start (Offsetting correction of contrast potential has been set.)
Perform automatic calibration
Automatic calibration
for each paper type
Value for 08-9059
To Next Page
Loading...
