Toshiba e-STUDIO6520c - Page 480

e-STUDIO5520C/6520C/6530C © 2008-2011 TOSHIBA TEC CORPORATION All rights reserved
ERROR CODE and TROUBLESHOOTING
6 - 98
[CB80] RAM abnormality
[CB81] Flash ROM abnormality
[CB82] Finisher main program error
1. Update the firmware version of the finisher control PC board (FIN).
2. Replace the finisher control PC board (FIN).
[CB83] Saddle main program error
1. Update the firmware version of the saddle control PC board (ADL).
2. Replace the saddle control PC board (SDL).
MJ-1103/1104
Is the error recovered when the power of the equipment is turned OFF and then back ON?
È
ÆYES End.
NO
Replace the finisher control PC board.
MJ-1103/1104
Is the error recovered when the power of the equipment is turned OFF and then back ON?
È
ÆYES End.
NO
1. Check if the conductor pattern on the finisher controller PC board is open circuited or short
circuited.
2. Replace the finisher control PC board.
[CB84] Punch unit main program error
Is the firmware version of the PNC board (HP) latest?
È
ÆYES Update the firmware of the PNC board (HP).
NO
Replace the hole punch control PC board (HP).
[CB91] Saddle flash ROM abnormality
Is the error recovered when the power of the equipment is turned OFF and then back ON?
È
ÆYES End.
NO
1. Check if the conductor pattern on the saddle controller PC board (SDL) is open circuited or
short circuited.
2. Replace the saddle control PC board (SDL).
[CB92] Saddle RAM abnormality
Is the error recovered when the power of the equipment is turned OFF and then back ON?
È
ÆYES End.
NO
Replace the Saddle control PC board (SDL).