Toshiba e-STUDIO656 - Paper Feeding System

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 31
4.5 Paper Feeding System
4.5.1 Paper feeder unit / Bypass feed unit
(1) Take off the right rear cover.
( P.4-4 "4.1.9 Right rear cover")
(2) Open the right center cover to disconnect 1
connector.
Fig. 4-86
(3) Remove 2 pins and take off the bypass feed
unit by lifting it and the feeder side center
cover up.
Fig. 4-87
(4) Open the right lower cover and take it off by
lifting it up.
(5) Pull out the drawer completely.
Note:
If the drawer is not pulled out completely,
when the paper feeder unit is taken off, the
sensor may get damaged.
Fig. 4-88
Bypass feed unit
Pin
Right lower cover