4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 41
[ 4 ] Separation roller
(3) Remove 2 screws to take off the solenoid.
1. When installing the solenoid, install it for
the edge of the solenoid to get in phase
with the edges of the plate.
2. When installing the solenoid, fix it at the
position where the bosses of two gears
are put each other.
3. Put on the spring in the place shown by
the figure.
Fig. 4-115
Fig. 4-116
(1) Remove 4 screws to take off the paper guide.
Fig. 4-117
Screw
Bypass pickup
solenoid
Marking
Spring
Paper guideScrew Screw
Screw
To Next Page
Loading...
