Toshiba e-STUDIO656 - Discharge LED (ERS)

4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 57
4.6.3 Discharge LED (ERS)
(5) Disconnect 2 connectors, remove 1 screw,
and then take off the wire cleaner position
detection switch (SW4).
Note:
Push the switch in the direction of arrow A to
fix it. Also, carefully insert the connector into
the terminal of the color of the harness, and
then bend the terminal 45 º.
Fig. 4-161
(1) Take off the wire cleaner drive unit.
( P.4-56 "4.6.2 Wire cleaner drive unit /
Wire cleaner drive motor (M12)")
(2) Disconnect 1 connector.
Fig. 4-162
(3) Lift the connector side of the discharge LED
slightly to release the lock, and then slowly
pull out the discharge LED from the guide.
Note:
Assemble the discharge LED so that all
fingers of the guide are hooked.
Fig. 4-163
ConnectorPurpleBlack
Screw
(
A
)
Connector
Discharge LED
Discharge LED
Latch
Lock pin