4
© 2012 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856(Ver03)
DISASSEMBLY AND REPLACEMENT
4 - 71
(2) Disconnect 1 connector to release the
harness from the clamp.
Fig. 4-200
(3) Remove 2 screws to take off the inner cover.
(4) Remove 1 screw.
(5) Remove 3 screws to take off the toner drive
section.
Fig. 4-201
(6) Disconnect 1 connector to release the
harness from the clamp.
(7) Remove 2 screws to take off the motor with
bracket.
Fig. 4-202
Connector
Connector
Clamp
Cover
Drive unit
Bracket
Connector
Gear
To Next Page
Loading...
