e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 124
(8) Remove 2 screws.
Fig. 4-349
(9) Take off the unit of exit guide and exit/
reverse guide.
Fig. 4-350
(10) Disconnect 2 connectors, remove 2 screws
and take off the reading end guide.
Fig. 4-351
(11) Remove 1 E-ring, 1 pulley, 1 pin, 1 timing
belt, 1 guide bushing and the bracket.
Fig. 4-352
Exit guide
Exit/reverse guide
E-ringPulleyPin
Timing belt
Guide bushing
Bracket
To Next Page
Loading...
