e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
DISASSEMBLY AND REPLACEMENT
4 - 150
4.12.36 RADF opening/closing sensor (SR15)
4.12.37 Original empty sensor (SR3)
(1) Take off the RADF rear cover.
( P.4-160 "4.12.54 RADF board bracket")
(2) Open the RADF and disconnect 1 connector.
(3) Release 2 latches and take off the RADF
opening/closing sensor.
Fig. 4-426
(1) Open the original jam access cover.
(2) Remove 4 screws and take off the sensor
bracket.
Fig. 4-427
(3) Disconnect 1 connector. Release 2 latches
and take off the original empty sensor.
Fig. 4-428
To Next Page
Loading...
