Toshiba e-STUDIO656 - Page 312

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
SELF-DIAGNOSTIC MODE
5 - 2
Notes:
• Do not enter any of the modes shown below since they are provided only for production. If
you do so, the equipment may not be restarted.
- [2]+[C]+[Power]
- [7]+[C]+[Power]
- [8]+[C]+[Power]
- [9]+[C]+[Power]
• When the optional FAX unit is installed, Faxes received automatically during the self-
diagnosis mode may not be printed out. Be sure to disconnect the modular code from the line
connectors (LINE1, LINE2) of the equipment before starting the self-diagnosis mode. Also, be
sure to finish the self-diagnosis mode by turning the power OFF and back ON before
connecting the modular code.
[D] State transition diagram of self-diagnosis modes
Fig. 5-1
*1 If you have used a self-diagnostic mode, turn the power OFF before the customer starts using the
equipment
*2 Mode shown in the table "[C] List of modes"
[E] About each mode
• Control panel check mode (01):
<Operation procedure>
Authentication
screen
Normal
Warming up
Ready
[POWER]
OFF
To user
Each mode
Self-diagnosis
mode
*1
*2
[POWER]
ON
[0][1]
[POWER]
LED lit/
LCD blinking
[START]
[START]
(Button check)
[POWER] OFF/ON
(Exit)