Toshiba e-STUDIO656 - Measurement at Replacement of High-Voltage Transformer

e-STUDIO556/656/756/856(Ver03) © 2012 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
6 - 42
6.8 Measurement at Replacement of High-Voltage Transformer
The high-voltage transformer does not need to be adjusted, however, when you check each value of
the main charger bias and the developer bias, it needs to be measured.
Note:
When carrying out the operation, be careful not to touch the electronic section because it is high
voltage.
6.8.1 Measurement
[ 1 ] Preparation
[ 2 ] Installing Jig
(1) Put in the door switch jig and slide it down.
(2) Rotate the jig counterclockwise by 90 degrees.
Fig. 6-24
Items to check Main Charger Developer Bias
Process Unit Take off from the equipment Remove the connector of the auto
toner sensor, and release the
developer unit from the drum.
Digital
Teste r
Function switch DC
Full-scale (range) 1000 V
Remarks Use a digital tester with an input resistance of 10 MΩ (RMS value) or higher.
How to turn ON the power Attach the door switch jig and start with the adjustment mode [05] while the
front cover opened.
Door switch jig