8
© 2011 - 2014 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO556/656/756/856/557/657/757/857
ERROR CODE AND TROUBLESHOOTING
8 - 143
[F102] HDD boot error
[F103] HDD transfer time-out
[F104] HDD data error
[F105] other HDD error
[F106_0] ADI-HDD error: Illegal disk replacement detected (ADI-HDD Exchange to SATA-HDD)
Classification Error item
Other service call HDD start error: HDD cannot become “Ready” state.
HDD transfer time-out: Reading/writing cannot be performed in the
specified period of time.
HDD data error: Abnormality is detected in the data of HDD.
HDD other error
Check item Measures
HDD
• Connector and harness check
• Check if the connector pins of the HDD are bent.
• Perform the bad sector check (08-9072). If the check result is OK,
recover the data in the HDD. If the check result is failed, replace the
HDD.
Replace parts Remarks
HDD
SYS board
Classification Error item
Other service call ADI-HDD error: The ADI-HDD has been replaced illegally to SATA-HDD
(normal type).
Check item Measures
Setting
Check if the HDD has been replaced with a SATA-HDD (normal type).
1. Start the equipment in the 4C mode: [4] + [C] + [POWER])
2. Check the type of the HDD shown on the top left of the control panel
display “Current HDD type”.
2a. In case of “SATA-HDD” (normal type), replace it with the original ADI-
HDD or a new ADI-HDD.
To replace with the original ADI-HDD, start the equipment in the
normal mode and then reinstall master data (HD Data) only if any
abnormality occurs.
2b. In case of “ADI-HDD”
• Check each item in the Measures field for the HDD.below
If the error still occurs, reinstall the master data (HD Data).
HDD • Connector check
• Harness check
Follow the procedure below if no abnormality is found in the check items
above.
1. Start the equipment in the 4C mode: [4] + [C] + [POWER] →
1. Revert factory initial status HDD
2. Reinstall the system software.
To Next Page
Loading...
