e-STUDIO520/523/600/603/720/723/850/853 © 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved
ADJUSTMENT
3 - 80
3.14.2 Registering the number of punch holes
This operation registers which puncher unit is attached to the IC on the punch driver PCB so that the
puncher unit can be identified by the finisher. For this reason, this operation must be performed when
the punch driver PCB has been replaced.
(1) Remove the rear cover of the finisher unit.
(2) Set bits 1 through 6 of DIPSW3 on the finisher controller PCB as indicated.
Fig. 3-93
(3) Set bits 7 and 8 on DIPSW3 on the finisher controller PCB to match the number of punch holes of
the attached puncher unit according to the table.
(4) Press SW1 on the finisher controller PCB. Press SW2 when setting a 2-/3-hole model (MJ-
6003N). Pressing this switch registers the number of punch holes to the punch driver PCB.
(5) Set all bits on DIPSW3 to OFF.
Number of Punch Holes
DIPSW3 bit settings
Push switch
bit 7 bit 8
2-hole OFF OFF SW1 (MJ-6003E) OFF OFF SW1
2-/3-hole OFF OFF SW2 (MJ-6003N) OFF OFF SW2
4-hole ON OFF SW1 (MJ-6003F) ON OFF SW1
4-hole ON ON SW1 (MJ-6003S) ON ON SW1
ON
12345678
To Next Page
Loading...
