© 2005 - 2007 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO520/523/600/603/720/723/850/853
TROUBLESHOOTING
5 - 95
5
[CF10] Undefined error code processing
(1) Is the error recovered when the power of the equipment is turned OFF and then back ON?
(2) If not as in step 1, check if the LGC board and IPC board are connected correctly.
(3) If the error has still not been recovered in step 2, check if there is any defect in the LGC board,
IPC board or finisher control board. If not, replace the LGC board, IPC board or finisher control
board.
07/04
To Next Page
Loading...
