Toshiba e-studio905 - Dns

• The above command specifies the number of concurrent diprint connections. Specify "multi" for
multiple connections or "single" for a single connection.
• The default is "multi".
dns
Use the "dns" command to configure or display DNS (Domain Name System) settings.
View settings
The following command displays current DNS settings:
msh> dns
IPv4 DNS server configuration
The following command enables or disables the IPv4 DNS server address:
msh> dns "ID" server "server address"
The following command displays a configuration using the IP address 192.168.15.16 on a DNS 1
server:
msh> dns 1 server 192.168.15.16
• You can register IPv4 DNS Server address.
• You can select an ID number between 1 and 3. You can select up to three ID numbers.
• You cannot use "255.255.255.255" as the DNS server address.
IPv6 DNS server configuration
The following command enables or disables the IPv4 DNS server address:
msh> dns "ID" server6 "server address"
• You can register IPv6 DNS Server address.
• The selectable ID number is between 1 and 3. You can select up to 3 ID.
Dynamic DNS function setting
msh> dns "interface_name" ddns {on|off}
• You can set the dynamic DNS function "active" or "inactive".
• {on} means "active" and {off} means "inactive".
Interface name Interface configured
ether Ethernet interface
Specifying the record overlap operation
msh> dns overlap {update|add}
• You can specify operations performed when records overlap.
5. Monitoring and Configuring the Printer
184
5