• update: To delete old records and register new records.
• add: To add new records and store the old records.
• When CNAME overlaps, it is always changed, irrespective of settings.
CNAME registration
msh> dns cname {on|off}
• You can specify whether to register CNAME.
• {on} means "active" and {off} means "inactive".
• The CNAME registered is the default name beginning with rnp. CNAME cannot be changed.
A records registration
msh> dns arecord {dhcp|own}
• dhcp: You can specify the method of registering an A record when the dynamic DNS function
is enabled and DHCP is used.
• own: To register an A record using the printer as the DNS client.
The DNS server address and the domain name already designated are used for the registration.
Record updating interval settings
msh> dns interval [1-255]
• You can specify the interval after which records are updated when using the dynamic DNS
function.
• The updating interval is specified hourly. It can be entered between 1 and 255 hours.
• The default is 24 hours.
resolv.conf display
msh> dns resolv
Specifying the protocol when asking names during dual stacking
msh> dns resolv protocol {ipv4|ipv6}
• Appears during dual stacking only.
domainname
Use the "domainname" command to display or configure the domain name settings.
View settings
The following command displays the current domain name:
msh> domainname
Interface domain configuration
msh> domainname "interface_name"
Remote Maintenance by telnet
185
To Next Page
Loading...
