9. Press [Change] right "Login User Name".
10. Enter the login user name, and then press [OK].
11. Press [Change] right "Login Password".
12. Enter the password, and then press [OK].
13. Enter the password again to confirm, and then press [OK].
14. Press [OK].
15. Press [Exit].
16. Press the [User Tools] key.
• To register the name, see "Registering Names".
• You can enter up to 191 characters for the user name.
• When using POP before SMTP Authentication, you can enter up to 63 characters.
• You can enter up to 128 characters for the password.
• To change the SMTP Authentication settings, repeat step 3 to 14.
• p.38 "File Transfer"
• p.254 "Registering Names"
LDAP Authentication
This section describes how to register LDAP Authentication.
For each user registered in the Address Book, you can register a login user name and login password to
be used when accessing a LDAP server.
To use a LDAP server, you need to program it beforehand. For details, see "Programming the LDAP server".
6. Registering Addresses and Users for Scanner Functions
302
To Next Page
Loading...
