The default setting is "0" mm.
• Tray 3 (Back Side)
• Max.: 2.0 mm
• Min.: -2.0 mm
• Step: 0.1 mm
The default setting is "0" mm.
• Tray 4 (Back Side)
• Max.: 2.0 mm
• Min.: -2.0 mm
• Step: 0.1 mm
The default setting is "0" mm.
• Tray 5 (Back Side)
• Max.: 2.0 mm
• Min.: -2.0 mm
• Step: 0.1 mm
The default setting is "0" mm.
• Tray 6 (Back Side)
• Max.: 2.0 mm
• Min.: -2.0 mm
• Step: 0.1 mm
The default setting is "0" mm.
• Tray 7 (Back Side)
• Max.: 2.0 mm
• Min.: -2.0 mm
• Step: 0.1 mm
The default setting is "0" mm.
• If sheets are delivered face down, turn them over horizontally and check the image position.
• You can also use Frame Image to adjust image position: under [Select Test Pattern for image Position
Adjustment], select [Frame Image].
0102: Adjust Image Position With Feed Direction
Adjust the vertical position of the printed image. Press [+] or [-] to move the image feed direction or
reverse feed direction.
8. Appendix
312
To Next Page
Loading...
