Toshiba ESTUDIO355 - Setup Flow for Lpr Printing

53
5
Setup Flow for LPR Printing
This equipment can be used with LPR printer connection using the LaserWriter 8 printer driver.
Setup Flow Description/Reference
Connect this equip-
ment
Connect the machine to your network with a network cable.
Reference: QUICK START GUIDE
• Chapter 4 “CONNECTING TO THE DEVICE”
“2. CONNECTING TO THE NETWORK”
Set up the TCP/IP
(IPv4)
Assign the IP address, Subnet mask, Gateway address.
Reference: USER FUNCTIONS GUIDE
• Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the TCP/IP Protocol (IPv4)”
Reference: TopAccess Guide
• Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the TCP/IP”
Set up the IPv6 Assign the IP address, Prefix, Gateway address.
Reference: USER FUNCTIONS GUIDE
• Chapter 4 “SETTING ITEMS (ADMIN)”
“3. SETTING NETWORK FUNCTIONS”
“Setting the IPv6 Protocol”
Reference: TopAccess Guide
• Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Network Settings”
“Setting up the IPv6”
Set up the Printing
Service
Enable the LPD Printing Service using TopAccess.
Reference: TopAccess Guide
• Chapter 7 “TOPACCESS ADMINISTRATOR MODE”
“Setting up from TopAccess”
“Setting up Print Service Settings”
“Setting up the LPD Print”
Mac OS 8.6
Mac OS 9.x
Mac OS X
Connecting over TCP/IP Network
Setting up the LPR
printer connection

Ð

Ð
Ð

Ð

Ð
Ð

Ð
Ð
