January 2000 © TOSHIBA TEC 1 - 7 FC-22 ADJUSTMENT
Transition diagram of self-diagnostic mode conditions
*1 : During the “Whole control-panel lighting mode”, copying is not possible. But after pressing [CLEAR]
to make the copier ready, you can make copies.
*2 : After having used the self-diagnostic mode, be sure to turn OFF and then ON the power before
returning the copier to the customer.
Normal
Warming up
Standby
[CLEAR]
[0][1]
All the displays on
the control panel lit
[0][3] [0][5]
[0][8]
Setting mode
Adjustment mode
Test mode
[Power] ON
Test print mode
[Power] OFF/ON
Hand over to user
*2
*1
[0][4]
To Next Page
Loading...
