January 2000 © TOSHIBA TEC 1 - 69 FC-22 ADJUSTMENT
Copy mode
Text /
Tex t
Printed
Photo Map
Item to be
Remarks
photo image
adjusted
Adjustment code 779 780 781 782 783 Yellow
0 0 0 0 0 Low density
Sub code 1 1 1 1 1
Medium density
2 2 2 2 2 High density
Adjustment code 784 785 786 787 788 Magenta
0 0 0 0 0 Low density
Sub code 1 1 1 1 1
Medium density
2 2 2 2 2 High denisy
Adjustment code 789 790 791 792 793 Cyan
0 0 0 0 0 Low density
Sub code 1 1 1 1 1
Medium density
2 2 2 2 2 High denisy
Adjustment code 794 795 796 797 798 Black
0 0 0 0 0 Low density
Sub code 1 1 1 1 1
Medium density
2 2 2 2 2 High denisy
The larger the value,
the darker the color to
be adjuted becomes.
Acceptable values: 0 to
255
1. 9 Color Balance Adjustment
Make a test copy and compare the image obtained with the current settings; if necessary, make adjust-
ment using the following procedure.
Note: Be sure that this adjustment be made after performing “1.7 Automatic Adjustment of Gamma Correction”.
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Input the code of required mode (color mode, copy mode, item to be adjusted) with digital keys and
press the [START] key.
(3) Select the density area to be adjusted with digital keys (0, 1 or 2), and press the [START] key.
0 : Low density (L) 1 : Medium density (M) 2 : High density (H)
(4) Input an adjustment value with digital keys.
(To correct an input value, press the [CLEAR] key.)
(5) Press the [SET] icon to have the value memorized.
촞
Returns to the display in (3).
(6) For resetting the value, repeat the steps (3) to (5).
(7) Press the [SET] icon or [INTERRUPT] key to store the value in memory.
→
The copier goes back to
the standby state.
(8) Press the [ENERGY SAVER] key and then press the [START] key to make a test copy.
(9) If the desired image density has not been attained, repeat the steps (2) to (8).
To Next Page
Loading...
