January 2000 © TOSHIBA TEC 1 - 79 FC-22 ADJUSTMENT
Note :
1. When winding the wires on the pulleys, take
the following precautions:
· Do not wind the wire on the pulley with
the wire twisted.
· Wind the wire strongly so that all the turns
of the wire are in firm contact with the
surface of the pulley.
· Each time you wind a turn on the pulley,
push it to the preceding turn so that all
the turns are closely wound.
2. When fitting wire holder jigs, take care so
that the turns wound on the pulleys do not
move or unwind.
No gap should exist.
e.g. Front side
<Relationship between wound turns and wire holder jigs>
3-mm dia.
ball terminal
Pulley
Wire holder jigs
Front side
Rear side
Wire holder jig
To Next Page
Loading...
