196 ACE-tronics G9 ASD Installation and Operation Manual
Trace Cycle
Program Utilities Trace
This parameter sets the record time for the Trace Data events selected at F742
– F745.
See F740 for additional information on this parameter setting.
Settings:
4 mS
20 mS
100 mS
1 Second
10 Seconds
Direct Access Number — F741
Parameter Type — Selection List
Factory Default — 100 mS
Changeable During Run — Yes
Trace Data 1
Program Utilities Trace Data 1
This parameter is used to select the Trace Data 1 item from Table 11 on pg.
244 to be read and stored in accordance with the setup of parameters F740 and
F741.
See F740 for additional information on this parameter setting.
Direct Access Number — F742
Parameter Type — Selection List
Factory Default — Output Frequency
Changeable During Run — Yes
Trace Data 2
Program Utilities Trace Data 2
This parameter is used to select the Trace Data 2 item from Table 11 on pg.
244 to be read and stored in accordance with the setup of parameters F740 and
F741.
See F740 for additional information on this parameter setting.
Direct Access Number — F743
Parameter Type — Selection List
Factory Default — Freq. Reference
Changeable During Run — Yes
Trace Data 3
Program Utilities Trace Data 3
This parameter is used to select the Trace Data 3 item from Table 11 on pg.
244 to be read and stored in accordance with the setup of parameters F740 and
F741.
See F740 for additional information on this parameter setting.
Direct Access Number — F744
Parameter Type — Selection List
Factory Default — Output Current
Changeable During Run — Yes
Trace Data 4
Program Utilities Trace Data 4
This parameter is used to select the Trace Data 4 item from Table 11 on pg.
244 to be read and stored in accordance with the setup of parameters F740 and
F741.
See F740 for additional information on this parameter setting.
Direct Access Number — F745
Parameter Type — Selection List
Factory Default — DC Voltage
Changeable During Run — Yes
F741 F745
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
