ACE-tronics G9 ASD Installation and Operation Manual 223
Analog Function Assigned Object 11
Program My Function My Function Analog
This parameter plays a role in the setup of the My Function feature by
selecting the functionality to which the adjustment of
F959 is applied.
Settings:
Disabled (None)
Acceleration Rate
Upper-Limit Frequency
Acceleration Multiplication Factor
Deceleration Multiplication Factor
Manual Torque Boost
Over-Current Stall (F601)
Thermal Protection (F600)
Speed Loop Proportional Gain (F460)
Drooping Gain (F320)
PID Proportional Gain (F362)
Direct Access Number — F961
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Analog Input Function Target 21
Program My Function My Function Analog
This parameter plays a role in the setup of the My Function feature by
selecting the functionality of the programmable Analog Input Function Target
21 terminal.
The function selected at F964 may be adjusted using the input analog control
signal selected here.
Settings:
Disabled (None)
V/I
RR
RX
Optional RX2+, RX2-
Optional V/I
Direct Access Number — F962
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
Analog Function Assigned Object 21
Program My Function My Function Analog
This parameter plays a role in the setup of the My Function feature by
selecting the functionality to which the adjustment of
F962 is applied.
Settings:
Disabled (None)
Acceleration Rate
Upper-Limit Frequency
Acceleration Multiplication Factor
Deceleration Multiplication Factor
Manual Torque Boost
Over-Current Stall (F601)
Thermal Protection (F600)
Speed Loop Proportional Gain (F460)
Drooping Gain (F320)
PID Proportional Gain (F362)
Direct Access Number — F964
Parameter Type — Selection List
Factory Default — 0 (Disabled)
Changeable During Run — Yes
F961 F964
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
