Toshiba G9 - Page 278

298 pages

To Next Page

To Previous Page

268 ACE-tronics G9 ASD Installation and Operation Manual

Figure 37. See Table 17 and Table 18 for the Associated Device. Dimensions are in in/cm.

efesotomasyon.com -Toshiba inverter,drive,servo,plc

Main Page

Default Chapter7
- Table of Contents7
General Safety Information11
- Safety Alert Symbol11
- Signal Words11
- Special Symbols12
- Equipment Warning Labels12
- Qualified Personnel12
- Equipment Inspection13
- Handling and Storage13
- Disposal13
Installation Precautions14
- Location and Ambient Requirements14
- Mounting Requirements14
- Conductor Routing and Grounding15
- Power Connections16
- Protection16
System Integration Precautions17
- Personnel Protection17
- System Setup Requirements18
Operational and Maintenance Precautions19
Motor Characteristics20
- Motor Autotuning20
- Pulse Width Modulation Operation20
- Low-Speed Operation20
- Overload Protection Adjustment20
- Operation above 60 Hz20
- Power Factor Correction21
- Light Load Conditions21
- Motor/Load Combinations21
- Load-Produced Negative Torque22
- Motor Braking22
ASD Characteristics23
- Over-Current Protection23
- ASD Capacity23
- Using Vector Control23
Installation and Connections24
- Installation Notes24
- Mounting the ASD25
- Connecting the ASD26
- Ace G9-120V-Pcb31
- ACE G9-120V-PCB Precautions31
- Terminal Functions32
- Communications33
- Alternate I/O Terminal Board33
- ACE G9-120V-PCB Specifications/Layout34
Cable/Terminal/Torque Specifications36
Electronic Operator Interface42
- EOI Operation42
- EOI Remote Mounting42
- EOI Features43
- EOI Remote Mounting47
System Operation50
- Operation (Local)50
- Default Setting Changes50
- Save User Settings51
Startup Wizard Requirements52
- ASD Control Configuration55
- Autotune Enable56
- Speed Control (F986)56
- Accel/Decel Times56
- Special Functions56
Command and Frequency Mode Control57
- Command Control (F003)57
- Frequency Control (F004)58
- Override Operation59
System Configuration and Menu Options62
- Root Menus62
Direct Access Information89
- Direct Access Parameters/Numbers89
Alarms, Trips, and Troubleshooting258
- Alarms and Trips258
- Alarms259
- Trips/Faults264
Enclosure Dimensions and Conduit Plate Information271
- Enclosure Dimensions272
Current/Voltage Specifications280
Dynamic Braking Resistor Specifications284
Short Circuit Protection Recommendations286
ACE-Tronics G9 ASD Optional Devices287

Toshiba G9 - Page 278

Table of Contents

Related product manuals