Toshiba G9 - Page 38

28 ACE-tronics G9 ASD Installation and Operation Manual
BRAKE-C — BRAKE-C is the common leg of a single-pole double-throw form-C relay. The
BRAKE relay is the Fault Relay by default, but may be programmed to any of the selections of
Table 10 on pg. 242. For additional information on this terminal see F132 and Figure 9 on pg. 28.
Note: The BRAKE-A, BRAKE-B, and BRAKE-C contacts are rated at 2 A/120 VAC and
2
A/30 VDC.
Figure 9. BRAKE Switching Contacts.
Note: The BRAKE relay is shown in the
de-energized state.
efesotomasyon.com -Toshiba inverter,drive,servo,plc