ACE-tronics G9 ASD Installation and Operation Manual 51
7 — Communication Option Board
Use this setting if using the optional Communication Board for frequency control.
8 — RX2 Option (AI1)
Used for a ±10 VDC analog input signal.
9 — Option V/I
Allows for the use of the optional voltage/current frequency-control interface.
10 — UP/DOWN Frequency
A discrete terminal may be configured to increase or decrease the speed of the motor by
momentarily activating the terminal by applying 120 VAC to the terminal. See
F264 on pg. 131
for additional information on this feature.
11 — Pulse Input Option
Used to allow the system to use a pulsed input for frequency control. See PG Input Point 1
Setting on pg. 125 for additional information on this feature.
12 — Pulse Input (Motor CPU)
Used to allow the system to use a pulsed input for frequency control. See PG Input Point 1
Setting on pg. 125 for additional information on this feature.
13 — Binary/BCD Input Option
Allows for discrete terminal to be used for frequency-control input.
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
