86 ACE-tronics G9 ASD Installation and Operation Manual
Motor Overload Protection Configuration
Program Protection Overload
This parameter is used to protect the motor from an over-current condition. The
type of motor being used and the Overload/Stall setting is selected here to
better match the application.
This parameter setting may extend the Over-Voltage Stall time settings.
This parameter may be affected by the setting of the Power Running Stall
Continuous Trip Detection Time (
F452).
Settings:
Overload Trip without Stall
Overload Trip with Stall
No Overload without Stall
Stall Only
V/f Motor-Overload without Stall
V/f Motor-Overload with Stall
V/f Motor-No Overload without Stall
V/f Motor-Stall Only
Direct Access Number — F017
Parameter Type — Selection List
Factory Default — Overload Trip
Without Stall
Changeable During Run — Yes
F017 F017
efesotomasyon.com -Toshiba inverter,drive,servo,plc
To Next Page
Loading...
