Toshiba G9000 SERIES - Figure 5-4: Installation of Jumper Wire on IOAU-19

12 G9000 TOSHIBA SYNC KIT 1000-2000kVA Installation Manual - 200151-001
5-6. Connect the jumper wire(Part# 3C) between the terminal 29 and 30 of TN13 on IOAU-19*.
Figure 5-4: Installation of jumper wire on IOAU-19*
Jumper wire connection will vary based on input port setting.
See chapter “6 SLAVE UPS Setting Procedures” and also refer to
“G9000 SERIES INSTALLATION AND OPERATION MANUAL 480/480V
1000/1330/1500/1660/2000kVA” for details of input contacts.
!
NOTE
Jumper (29 - 30)
Jumper wire is included in this KIT.
In case of field installation,
specification of jumper wire is as follows.
Terminal block:
WAGO CAGE CLAMP 236-404
Wire size:
AWG 28 - AWG 12
TN13