- 994 -
4.10.4 Signals
◆ Signal monitoring points in BI module at IO#1 slot
GENBI (Function ID: 580001)
Status of binary input circuit BI1 at IO#1 slot
Status of binary input circuit BI2 at IO#1 slot
Status of binary input circuit BI3 at IO#1 slot
Status of binary input circuit BI32 at IO#1 slot
◆ Mapping points in BI module at IO#1 slot
GENBI (Function ID: 580001)
Note: In the table above, the user will only find Element IDs and their names for the 1
st
slot, but a 2
nd
and other slots are also provided in the GENBI function. We have
omitted the Element IDs and their names for the other devices to improve
readability. Use the rule described below when the user wishes to obtain the
Element IDs and their names for the other devices.
Rule: The same types of signal monitoring points are provided in every circuit;
hence, the user can find the same ones for all of the other circuits. For
example, when the user wishes to find the “SLOT2 GBI02_STATE” point
for the 2
nd
circuit, use the description of SLOT1 GBI01_STATE in place of
“SLOT2 GBI02_STATE”. The user can obtain the ID value of “SLOT2
GBI02_STATE” by using the following steps:
Step 1 Find the element ID for SLOT1 GBI01_STATE (i.e.,
“0010001001”)
Step 2 Identify the number at the fifth and sixth digits from the
To Next Page
Loading...
