- 1029 -
5.2.3 Constitution of VCT
Figure 5.2-5 shows VCT terminal block together with its schematic diagram (termed ‘VC1’);
the same terminal screw numbers are shown on both the left and the right figures. The user
should note that the last screw No. 30 and FG terminal are connected with a short-bar by
default.
Figure 5.2-5 VC1 terminals (Rear view)
1
Note: Short-bar between the screw No. 30 and FG is connected by the manufacturer.
2
Note: The figure is just drawn for general instruction about VCT structure. The number
of VTs and CTs on VCT is dependent on the VCT type that the user has ordered.
Module type
Schematic diagram
numeric
Frame ground
terminal on the case
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
To Next Page
Loading...
