Toshiba GR200 Series - Page 1083

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1060 -
Figure 5.4-4 BO and BIO setting tables related to IO_slot1 and IO_slot3
The setting table of section 5.4.6 is available for all binary IO modules except for the BI2A
module; thus, the user should understand and select the setting points that are relevant to the
BI1A module. That is, for the BI1A, the user should choose the setting items of reference (i.e.,
binary input circuits #1 to #18) from IO_SLOT1 setting table. On the other hand, for the BIO1A
module, the user should choose the setting items of reference (i.e., binary input circuits #1 to
#7) from IO_SLOT3 setting table. The IO_SLOT3 setting table for the binary input circuits are
shown in sec. 5.4.6. The setting operation via the IED screen is discussed later. (See chapter
User interface: I/O setting sub-menu )
IO#1
IO#2
IO#3
IO#4
IO#
n
IO_SLOT1
Setting table (input)
IO_SLOT3
Setting table (in & out)
Setting targets: BI1–BI18
and Common.
a. Setting targets for BI1A (IO#1)
c. Setting targets for BIO1A (IO#3)
Setting targets: BI1–BI7
and Common.