Toshiba GR200 Series - 9.6 Statistics data (Counter group); 9.6.1 Count information on the screen; 9.6.2 Report setting for GCNT (Dead band feature)

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1200 -
Statistics data (Counter group)
The user can check the counting numbers provided by the general counter function†. Table
9.6-1 shows the user to find the count numbers in the counter group.
Table 9.6-1 Counter data
Group
Counter number
displayed
Origin of info (default)
Correspondences
to GCNTs†
Counter
ARC1 CLOSE COMMAND
ARC function‡
GCNT01
ARC1_SPAR
ARC function
GCNT02
ARC1_TPAR
ARC function
GCNT03
ARC1_MPAR
ARC function
GCNT04
ARC2 CLOSE COMMAND
ARC function
GCNT05
ARC2_SPAR
ARC function
GCNT06
ARC2_TPAR
ARC function
GCNT07
ARC2_MPAR
ARC function
GCNT08
COUNT9
(Not assigned)
GCNT09
COUNT10
(Not assigned)
GCNT10
….
….
….
COUNT32
(Not assigned)
GCNT32
†Note: See Chapter General control function: Counter function for the general (GCNT) .
‡Note: See Chapter Relay application: Autoreclose for more information.
9.6.1 Count information on the screen
The user can see the count number in the counter group. Figure 9.6-1 illustrates the count
numbers provided by the ARC function.
Figure 9.6-1 Example of Counter screen
Note: See Chapter User interface: Monitoring sub-menu: Statistics sub-menu .
9.6.2 Report setting for GCNT (Dead band feature)
The data collected with the GCNT functions will be sent to the network; thus, the user should
set a regulation value using the SD feature in the GCNT function. See section Setting for the
report (Dead band) in the GCNT function.
Counter
10:48 1/32
ARC1 CLOSE COMMAND +
0
ARC1_SPAR +
0
ARC1_TPAR +
0