Toshiba GR200 Series - (v)-1 Screen jump function: To configure the screen jump function, follow the steps as shown in the figure below.

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1462 -
programmed using settings. Six screens are configured for six of the function keys (F1 to F6),
respectively, as the default settings shown in Table 5.6-3.
Table 12.5-3 Function keys which are configured to navigate a menu
Function Key configured
Menus
F1
Metering
F2
Fault Record
F3
Event Record1
F4
Event Record2
F5
Event Record3
F6
Diagnostics
Screen jump function: To configure the screen jump function, follow the steps
as shown in the figure below.
Figure 12.5-13 Operation of screen jump setting
F1 Key Function
10:48 3/3
Screen Jump
Assign Signal
_No Assign
OC
10:48 1/4
_OC1EN +>
On
OC2EN +>
On
OC3EN +
Off
[►]
[ENTER]
Setting
Change Setting?
ENTER=Yes CANCEL=No
Function Key
10:48 1/7
F1 Key >
F2 Key >
F3 Key >
F4 Key >
F5 Key >
F6 Key >
[ENTER]
[ ] x 2
F1 Key
10:48 1/3
*Function +
No Assign
Signal +
No Assign
Logic
Instant +
F1 Key Function
10:48 1/3
*Screen Jump
Assign Signal
No Assign
[◄]
[◄] x 2
F1 Key
10:48 1/3
*Function +
Screen Jump
Signal +
No Assign
Logic
Instant +
[ENTER]
[CANCEL]
[
An Example
]
F1 Key
Register this screen
to F1 Key?
ENTER=Yes CANCEL=No
Push [F1]
for 3s.
The “Screen Jump”
setting is
confirmed. Do the
next step to select
a screen.
[▼] x 2
[ENTER]
The selected screen is assigned to [F1].