Toshiba GR200 Series - Step6: Write settings with altered code; To write the settings corresponding to the altered code, use the GR-TIEMS. For example, after rated current changed to 1 A, rewrite the setting items into the IED using the altered ordering code (see Figure 13.4-1 about the altered code; in this examp...

6F2S1914 (0.49)
GRL200 (Soft 033 & 037)
- 1501 -
Information
10:48 1/9
[IED TYPE]
GRL200
__-1033-1J2-2E
[Serial No.]
No XXXXXXX123
Line protection IED
GRL200
-11-224-12-1J-30-120
5A
50 / 60
100-120
110-250
Month, Year
****** ** ***
Rated current (In) on the nameplate: 5A rated set in the Manufacture
TOSHIBA ENERGY SYSTEMS & SOLUTIONS CORPORATION
Code at
Positon K
Rated
current
1
1A
2
5A
Rated current (In) in the IED: 1A rated changed by the user
Original code
Altered code
-11-224-12-1J-30-110
Figure 13.4-1 How to check the changed rated current with the altered code
†Note: For the LCD screen operation, see Chapter User interface: Information sub-menu .
‡Note: To know how to read the code, refer to the preceding section Unpack and
inspection of hardware and software .
Step6: Write settings with altered code
To write the settings corresponding to the altered code, use the GR-TIEMS. For
example, after rated current changed to 1A, rewrite the setting items into the IED
using the altered ordering code (see Figure 13.4-1 about the altered code; in this
example: GRL200-11-224-12-1J-30-110-1033-1J2-2E). Figure 13.4-2 shows how to
write the settings.