Change place and contents
Added and revised w.r.t the communication IF for Misc.
(RS485 and Fiber optic)
Corrected element ID w.r.t ‘OC1_BLOCK’ in Figure 1.7-
1
Corrected ‘OC1_BLOCK’ and ‘OC1_INST_OP”
connection points in Figure 2.15-8
Added the monitoring point about OC1_BLOCK and
OC1_INST_OP in Fig 2.15-8
Added the monitoring point about EF1_BLOCK and
EF1_INST_OP in Fig 2.16-6
Added the monitoring point about OCN1_BLOCK and
OCN1_INST_OP in Fig 2.17-6
Revised the table of Data IDs in OCN function
Added signal lists in section ‘Local, remote and PLC
control’
Corrected ‘LRSW01_PLC_SGN01’ and ‘02’ connection
points in Figure 3.5-1 and Table 3.5.3
Deleted ‘COMFEDE’ in the Data exchange at General
performance
Added the tips for the DIFL#2 elements in the dual
communication mode in Fig 2.2-3, 2.6-2, 2.7-2
Corrected and redrawn the scheme logics in ZS and ZG
Corrected the setting names to select the time
characteristics and the number of elements in OV
Corrected the setting names to select the time
characteristics and the number of elements in OVS
Corrected the setting names to select the time
characteristics in UV
Corrected the setting names to select the time
characteristics in UVS
Simplified the description of the control hierarchy
Added the notice that the local mode will be canceled
when key operations are not carried out.
Corrected the signal for the control hierarchy in Fig.
3.7-1&14 and Table 3.7-4&9
Added the contents about APPL functions
Added the contents of threshold setting for dropping
DC voltage generated in the PWS
Revised the contents for the occurrence of Power errors;
added the info. about PWS threshold set
Corrected the number of elements in ZS,ZG relays in
the Functional data
Added the contents of PRP protocol
Added the contents of LRE error in PRP protocol
Added the DataID table in the CHK_FPGA function
Revised the range (–10° to +55°C) of the operating
temperature for the new one (–25° to +55°C).
To Next Page
Loading...
