Change place and contents
Revised the contents for removal and attachment;
Removed the contents for conventional IED cases
Corrected ZS and ZG equations (2.10-17) and (2.10-18)
Revised the setting Tips and notices of [SYN-Angle]
and [T_SYN] in VCHK
Corrected the incoming voltage about the relationship
between Vs, Vs2, Vb in VCHK
Corrected the Equation expansions in Equations (2.36-
2) and (2.36-6)
Corrected Ry addresses of Star network in Fig 2.37-1
Added the setting Tips and notices of [SyncR1-Angle]
and [SYNC01_TSYN] in Sync check
Corrected Function ID number of CHK_PLC_DAT
Added the notice in the content of Communication
failure (Com fail)
Corrected the definitions of quality bits in IEC61850
Revised the values of Time-tagged message in Table
11.4-3&4
Revised the DPI number and its characteristics in
Chap 11.4.5.(ii)-6
Corrected the “Sr1” and “Sr2” validity values “ in the
PIXIT table
Added the notes for Dielectric voltage test
Corrected the signals coming from DIFL function in
Fig. 2.7-3
Corrected the contents about synchronism condition;
Revised the Notice and tips for SYN check relay
Revised the Tips and notices of Synchronism-relays in
SYNDIF
Modified the LRE error message
Added HSR and RSTP protocol
Added an explanation of white-plastic-sheets for
covering the screw holes on the case sides
Added RPR/HSR, RSTP ordering ‘4’ at position ‘U’ in
Software selection; Remove selection of ‘3’ code
Revised the contents of rack mounting kits; modified
the contents about rack mounting
Republished under the spin-off company
Corrected the delay difference equation (2.35-6) and
the range of Tdd setting with [CH1_TCDT]
Revised the contents for changing rated current on
VCT
Added how to change the CPU to the constrain mode
with a jumper
Deleted the contents about GIO communication
module; revised the rule on Table 5.3-3
Corrected the notice about 61850 quality value in Table
To Next Page
Loading...
